Robsscooby

iTrader: (1)

Hi peeps
bit stuck with out showin a picture
I have brought a new sump for my scooby and the rubber seal
that sits round the tube that sits against the block when on
I believe the tube runs through sump to drain hole
its not the sump gasket its the little seal inside the sump
same size as a 10p coin

merlin24

iTrader: (1)

That tube is the return to sump from the breather/seperator plate on the back of No.3 cylinder.
Just use the seal from the old sump if you are stuck, bit of 3bond on it will do the job just right.

Mick

Robsscooby

iTrader: (1)

This is my problem my old sump has 2 seals on
and I have been told should only have one on
would this cause oil pressure problems

merlin24

iTrader: (1)

It should only have one seal on it and No, it will not cause any oil pressure problems as it a gravity return of any oil and blowby gases from the breather/seperator plate to below the oil level in the sump.

Mick