Hi Guys, im pretty new on this forum and have rarely posted so i may well be in the wrong area! Although everyone seems mega helpful on the PMs etc so hopefully will get a good response!

Anyways basically ive recently purchased a 2001 jdm v7 impreza sti engine, and its wiring loom, for my VW beetle.

I intend on grafting the loom into the VW loom and only run the management side of the engine loom/wiring and cut out everything surplus.

I was going to start but removing every cable that does not go into the ECU connector. But keep, the Fuel pump/gb neutral switch/rev counter cables and perhaps a few others, yet to think about...

Anyways, i am really struggling to find a wiring diagram, for the motor, or ideally just the engine management side.

If anyone can point me in the right direction id be mega grateful! thanks!

 

Virtually impossible to get hold of manuals for JDM models.

Below are links to the electrical drawings for the MY01 and MY04 "Global" Imprezas which may or maynot be useful to you.

Problem is JDM cars have equipment that is introduced later in the Rest of the World models and also some of the wiring can be different and have different colour coding.

http://subaru-car.ru/imp1/imp01_wir_1.pdf

http://subaru-car.ru/imp1/imp01_wir_2.pdf

http://subaru-car.ru/imp1/imp01_wir_3.pdf

http://subaru-car.ru/imp4/imp04_wir_1.pdf

http://subaru-car.ru/imp4/imp04_wir_2.pdf

http://subaru-car.ru/imp4/imp04_wir_3.pdf