When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
As title says really.
I was taking my TMIC off and I have managed to split the rubber hose that is under it!!! The one where the dump valve attaches.
Anyone local got a spare one??
are you after the rubber Y pipe? as i have changed all the pipes on mine and might possibly have a spare pipe but wont knoe till i get home from work and have a look around
are you after the rubber Y pipe? as i have changed all the pipes on mine and might possibly have a spare pipe but wont knoe till i get home from work and have a look around
I think so yes bit of a scoobie newbie.
Looks like this (held together with IC upside down):
Where its snapped, very clean break:
Other end still attached to IC:
Mate you'd be a life saver if you have one.
Mine is a 96/P WRX import with a slanted TMIC if that makes any difference.
Wont fit Stu, I have one off a V2 WRX which that part is, but it wont be off for a couple of weeks. Alternatively just buy one of these which are much better
have put the feelers out so may be able to get one, fingers crossed, but a good shout with the samco, I couldnt find any that were much less than about £70!
Cheapest I have found as I was going to buy one to delete all the ripples in the OEM pipe. All you do is measure up the samco to the pipe you have, cut, jubilee the samco to the remaining hard pipe and it's job done
mine is a 96/p as well but ive got the straight TMIC with the Y pipe and the dumpvalve comes off the IC so the pipes i might have wont fit ill double check what i have at home
Cheers for all the thoughts guys, no worries wongy starting to realise mines got certain bits but not others,your right I don't think they will.going to a place tomorrow where they've rallied the cookies,to get a bit of silicone measured :-)