help with morettes on bugeye essex/london
#1
help with morettes on bugeye essex/london
anybody in essex/london have morettes on their bugeye wrx, i need help.
basically ive taken it apart to give it a good clean, and i had a problem when i flash my lights too( thought it was a loose connection). stupid enough, i didnt write down what wire connects with which, so i cant get the headlights and full beam to come back on.
sidelights and indicators still work though
i would appreciate any help. if i could be cheeky enough to ask if i could come by, and just copy your wiring that will be amazing
wiley
______
basically ive taken it apart to give it a good clean, and i had a problem when i flash my lights too( thought it was a loose connection). stupid enough, i didnt write down what wire connects with which, so i cant get the headlights and full beam to come back on.
sidelights and indicators still work though
i would appreciate any help. if i could be cheeky enough to ask if i could come by, and just copy your wiring that will be amazing
wiley
______
#2
Track Day Organiser
Does this help
The Subaru headlight system is common positive, switched ground. The wiring of the headlight connectors in the [WRX] is as follows-
Driver side-
common positive = red/light blue (center terminal on connector)
low beam switched ground = yellow/red
high beam switched ground = red
Passenger side-
common positive = light blue/white
low beam switched ground = yellow/red
high beam switched ground = red
The wiring on the Morettes-
Common = gray
Low beam = yellow
High beam = blue
Both sides on the Morettes are the same colors. The gray common should be connected, through the harness adapter, to the common positive for each side. The low and high beam wires should go to their respective switched grounds
The Subaru headlight system is common positive, switched ground. The wiring of the headlight connectors in the [WRX] is as follows-
Driver side-
common positive = red/light blue (center terminal on connector)
low beam switched ground = yellow/red
high beam switched ground = red
Passenger side-
common positive = light blue/white
low beam switched ground = yellow/red
high beam switched ground = red
The wiring on the Morettes-
Common = gray
Low beam = yellow
High beam = blue
Both sides on the Morettes are the same colors. The gray common should be connected, through the harness adapter, to the common positive for each side. The low and high beam wires should go to their respective switched grounds
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM