Decal kit fitter
#4
Scooby Regular
Join Date: Feb 2006
Location: Going further than the station and back !!! ZZZZZZZZZzzzzzzzzzzzz
Posts: 11,097
Likes: 0
Received 0 Likes
on
0 Posts
tom,
read up a bit about it.
there are some good tips
take your time
use water in a spray gun if you have to
read up a bit about it.
there are some good tips
take your time
use water in a spray gun if you have to
#5
Scooby Regular
iTrader: (2)
as per phil's post. you'll be lucky to get someone to fit it who didn't cut it. one because they like a particular type of vinyl and guessing 2 because they can make more money out of you as dazza said take your time, mix up a small amount of soap liquid in a spray bottle with warm water and get a poly filler plastic applicator and wrap it in a piece of mf cloth or terry towel. have a hair dryer to hand and a good sharp scalpel or stanley knife.
make 110% sure that the surface you are to work on is clean. wash it, clay bar it and wash it again before starting to apply. above all take your time. don't rush it and you'll be fine
make 110% sure that the surface you are to work on is clean. wash it, clay bar it and wash it again before starting to apply. above all take your time. don't rush it and you'll be fine
#7
Scooby Regular
Join Date: Feb 2006
Location: Going further than the station and back !!! ZZZZZZZZZzzzzzzzzzzzz
Posts: 11,097
Likes: 0
Received 0 Likes
on
0 Posts
tom the 555 kit should be much easier than the swoosh...
find a nice covered area to do it with no wind !!! lol
find a nice covered area to do it with no wind !!! lol
Trending Topics
#10
Scooby Regular
Join Date: Jun 2008
Location: wherever my car takes me
Posts: 831
Likes: 0
Received 0 Likes
on
0 Posts
Where area are you from?
I fitted mine, and had no problems doing so, if you are close to me, come and have a look at my work and if you like it, ask me for a quote to do yours.
I fitted mine, and had no problems doing so, if you are close to me, come and have a look at my work and if you like it, ask me for a quote to do yours.
Thread
Thread Starter
Forum
Replies
Last Post