Boost Solenoid 2/3pt on a 20g
#1
Boost Solenoid 2/3pt on a 20g
Hello all, My V3 JDM STi was running a VF23, but in progress of a build i have bought a TD05-20g ported from JMG. I also have bought a 3 port boost solenoid as the V3 ran a 2 port.
Question is do i still run the 20g via the 2 port with the pill in situ or do i remove the pill and direct feed from turbo housing to actuator?
If a diagram could be shown with a 2 port sol that would be appreciated as its going on tomorrow and mapping late march so ideally id like to run it safe until mapped.
Thanks in advance
Question is do i still run the 20g via the 2 port with the pill in situ or do i remove the pill and direct feed from turbo housing to actuator?
If a diagram could be shown with a 2 port sol that would be appreciated as its going on tomorrow and mapping late march so ideally id like to run it safe until mapped.
Thanks in advance
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM