Welloilbeefhooked

iTrader: (3)

Just started to play with my ecu settings and found that after altering my boost target map it results in its showing -1.00 in all cells. Managed to change the max duty and that is fine. Any ideas?

Jolly Green Monster

iTrader: (4)

Should be able to select the cells and just type a number or use page up and page down.

Welloilbeefhooked

iTrader: (3)

Simon, I can do that and entering a value into a cell works fine. The problem is that when I create an offline map and I have edited the boost target map and saved it, it then reopens with every cell in that table showing -1.00

Thats what I just don't get.

Jolly Green Monster

iTrader: (4)

sounds like possibly a glitch.. I obviously only alter when plugged into customers car..

Welloilbeefhooked

iTrader: (3)

Found it!

I was loading all parameters when viewing the map. If I load just the ones I want, Ign Base, Fuel, Boost target, min and max boost duty it works fine and displays fine.

I'm really only producing a 6s map with wastegate boost pressure and few degrees of timing removed so I can drive and test the car until I can have it correctly mapped.

Jolly Green Monster

iTrader: (4)

nice one