quick question
05 January 2014, 10:48 AM
#1
Scooby Newbie
Thread Starter
Join Date: Nov 2013
Location: brighton
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
quick question
hi all, if i can get hold of a ecutek in a j2 ecu licenced, can i put it in my e3 ecu??
is there a slot for the ecutek or does it need soldering??
thanx mick
is there a slot for the ecutek or does it need soldering??
thanx mick
05 January 2014, 11:02 AM
#2
Ecutek is not a chip/slot its a software update on the ecu, so you would replace the complete ecu
j2 ecu is a jdm sti ecu and is not a straight swap into a uk car as from what i remember the fuel pump and possibly crank sensor use different ecu pins.
j2 ecu is a jdm sti ecu and is not a straight swap into a uk car as from what i remember the fuel pump and possibly crank sensor use different ecu pins.
05 January 2014, 11:19 AM
#3
Scooby Newbie
Thread Starter
Join Date: Nov 2013
Location: brighton
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
god that was quick thanx again gambit, thats good no i aint bothering with the fath then, ill just get jgm to do my e3, thanx again sir apprec mick
21 January 2014, 02:44 PM
#5
Scooby Newbie
Thread Starter
Join Date: Nov 2013
Location: brighton
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
another sorry gambit does a y7 come from a uk2000 and will it fit in for my e3 uk without any wiring changes??? as a y7 jgm ecu has come up thanx again mick
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM