turbo2000 to p1 swap, ecu problem please help
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Nov 2010
Location: barañain, basque country
Posts: 142
Likes: 0
Received 0 Likes
on
0 Posts
turbo2000 to p1 swap, ecu problem please help
Hello friends, i install on my turbo MY00, engine and gearbox from my prodrive p1, becouse im building the p1 from zero.
Im having some problems with the ecu, looking in this forum and in www.jollygreenmonster.co.uk i managed to start the car, but check engine light its on and the car dont pas 5k rpm. I swaped some wires and change the pump relay pin, attached a picture where I indicate that I have changed.
my question is... in conector "136" the GND pin, number 1, swap with pin number 21, but the pin number 21, its the oxigen sensor signal.
can someone help me? thank you very much, im geting crazy
Im having some problems with the ecu, looking in this forum and in www.jollygreenmonster.co.uk i managed to start the car, but check engine light its on and the car dont pas 5k rpm. I swaped some wires and change the pump relay pin, attached a picture where I indicate that I have changed.
my question is... in conector "136" the GND pin, number 1, swap with pin number 21, but the pin number 21, its the oxigen sensor signal.
can someone help me? thank you very much, im geting crazy
Thread
Thread Starter
Forum
Replies
Last Post
crazyspeedfreakz
Wanted
17
05 October 2015 07:19 PM