Hello guys, I purchased my first Subaru 06 Hawkeye wrx just over a week ago and I've had a engine light come on with the code P1410, something to do with a low circuit voltage on the secondary air pump ! I know this as I have a obd2 scanner. I cleared the code and all was fine for a day and then yesterday the light came back on with this new code P2444 which is the secondary air pump stuck on ! .
I've been trawling the net for hours and it would seem this is a common fault on the 2.5 engines as its a system that was added as I kinda after thought to bring emissions down on start up and doesn't effect the running of the car.
My dilemma is its very expensive to replace all the parts so I've read you can take it off, blank off the feed into the engine and re-flash your ECU to not read the codes, has anyone else done this and where did you get it done ?? I'm based in the south east, help please lol !u

 

Hi there

Speak with Neil@Slowboy racing he is located near Brands Hatch and I'm sure he will able to help you with this

Think Cosworth making and selling those blanking plates

Jura

 

roger clarke do a kit as well its cheaper than the cosworth one and as you dont see it no point paying extra

 

if your after a new pump ive my one i had removed?

 

Just spoken to slow boy racing near Brands hatch and they have removed the system and erased the codes many times before, and the price was very reasonable so I'm going to book it in. Ill let you all know how I get on ; )

 

The guys at Slowboy racing were bang on, all done and dusted in two hours excellent service ! No engine light ; )