ukpaisley

iTrader: (4)

I have my 1993 WRX up and running and need to get a map on it as soon as poss it has a few mods, 20G , 550cc inj, 2.5 conversion.

I have been waiting for my ECU back from F.W. upgrade, but as I plan just a safe running map with minimal boost I am thinking ESL and a quick road or dyno map to see there is no problems.

Any ideas ?

dynamix

iTrader: (3)

Hi mate - I am in that area next week and could sort ESL out and either road map or dyno map in Durham ...

Jolly Green Monster

iTrader: (4)

Whats the Alcatek ecu number, can chase it.

Seems silly to payout for it to be mapped twice. Unless you intend selling the alcatek etc

dynamix

iTrader: (3)

true - didnt read the firmware upgrade as that.

ukpaisley

iTrader: (4)

Sticker on the board with E1S96.0178

Sticker on the Socket with ALS 62074 65385

Just time is running out, I may be away end of December for some time, only back in the UK a few weeks at a time. just want the car to be roadworthy, I am not even going to put the FMIC on, just waiting to get another opotunity to get a 6 speed in, then realy go for it!

Next week would be good, I realy intend to remove the MAF and just go to a MAP ,

I just want safe map, to get it going, then more mods later take the 20G boost up and dump the slanty IC.

Jolly Green Monster

iTrader: (4)

Just spoke to Andy and you are 2nd in the queue and should have it out the door this week.

Can do it next week if suits. Cant remember without looking in your original email where in ne you are.

Simon