Hello,


I'm running a 6S ecu with an ESL daughterboard on a 98 turbo GC8, when i try a connection i have this message in red: "ESL 97/98 Version No Supported"


The connection is via an OBD cable from ESL and i'm using the software available on the ESL FB page.


I didn't do the switch to the crank/camshaft wire or the fuel pump wire relocation.


I don't know if there is another version of the software.


Anyone have an idea ?




i'm French so, sorry for my bad English

 

what version is your ESL board, do you have pictures of it? Could it be the board is old/2nd hand and too old to use the current software? You can also email ESL themselves for support - they would know the product best.

 

Here's a picture of the daughter board


I've chatted with someone on the ESL fb page and it said that he had no idea what happened.

Maybe I should send an email...

Problem is that I buyed the ECU from eBay and not from them...

 

Here's a picture of the daughterboard :



I already talk to someone from ESL on their FB page and the guys told me he had no idea.

Problem is that i buyed it on ebay and not directly from ESL.

I think i should send them an email ...

 

i can't read the ESL numbers at the bottom of the pic - your image goes all pixely when i try to zoom in. It should say something like "ESL Live 96-98 v1.1" and its the v1.1 bit that's important. But yeah contact ESL directly or pop round to your closest dealer (i'm probably a few hundred miles too far from you) and they should be able to plug their cable in and see what it's saying.