Got a couple of questions on mapping please.

Iv got a version 3 STi with the following mods:

ESL ecu mapped by Duncan of Race Dynamix (dual map and running mafless)
Unknown 3" decat downpipe
Prodrive 2.5" cat back exhaust
K&N panel filter
225 walbro pump
Aftermarket recirc valve

I'm looking at getting a 2.5" afterburner vortex angled cat back to replace the prodrive and also putting an Apexi cone filter on, The MAF sensor is still on the induction pipe so want to remove this at the same time. I assume the map wouldn't need altering with these additions?

I'm only putting the cone on as I have a FMIC to go on but it won't fit with air box still in.

I'm not aiming for big power, it's running 321/310 at the moment but want the fmic on more for reliability on trackdays rather than letting the tmic struggle.
But if it would do 330/330 that would be nice.

Is there any other parts that I would need? 3 port solenoid for example?

Also is it now possible to add ALS and launch control to the ESL? I would like Duncan to remap it as he did it previously so hopefully it will be straight forward

 

You might need some slight alterations to fueling when going for a cone filter,but since you're going fmic then you will be getting a map tweak anyway.
The Motorsport pack is cool,won't take Duncan long to do,just a case of loading the software on and putting a switch in.
My ALS is on a switch but I have my LC on all the time and set to 4k rpm.
It also comes with flat foot shift but you would need an additional switch putting on the clutch pedal(not a big job tho)

 

Thanks for that mate.
Just need to wait for weather to improve so I can fit the parts and then get in touch with Duncan.