Hi guys,

Any ideas what sort of figures would I be looking at for a remap on my blob eye Wrx?

Has the prodrive pack already, lightened pulleys, sti top mounted intercooler and decat up pipe.

Cheers

Luke

 

Needs a Sports Cat/decat fitted. That's where the restriction is and that's where increase power will be found. Not really cost effective to remap without the exhaust post turbo sorted.

Lightened pulleys - negligible increase

sti top mounted intercooler - Standard WRX I/C is not a restriction until well into the 300s, so no real gain to be had. Will increase lag as more volume to be filled, if anything.

decat up pipe - will reduce spool time which is good but doesn't do much for power increase.

Maybe 270 with that lot, depends what health your engine is in currently.

With sports/decat and probably an uprated fuel pump, you would be looking at 280+

 

Like above I have a blob wrx with turbo back decat system and panel filter made 275.5 on rollers after being mapped

 

Cheers lads. Any ideas with regards to the ppp of any of the cats are deleted on this?

 

The second rear cat is deleted as part of the PPP on the Blob WRX. The the up pipe and primary cats remain. It's the primary cat that is restricting the power.

I'd look to get a Sports Cat fitted before a remap if it was my money. Decent panel filter and uprated fuel pump too.

 

280 bhp/290 torques on by Blob with filter, scrubber cat removed and a deres cat back.
Yes, up/down cats in place.
Yes, its been verified on two Rroads