Query about fitment of Magnex centre decat
#1
I have just fitted the Magnex centre section with resonator. What I wanted to know was weather I should tighten the bolts with the springs fully as I have noticed that the springs were nearly fully compressed and the nut was still tightening up. I did use the longer bolts supplied with the exhaust. Should you leave a bit of slack to allow it to flex?
Stuart
Stuart
#2
Stuart,
Fitted one about 6 months ago. Junked the original springs(& bolts) as they weren't quite long enough. Replaced with stainless bolts, nuts and washers - no problems with leaks or rattles.
Kevin.
Fitted one about 6 months ago. Junked the original springs(& bolts) as they weren't quite long enough. Replaced with stainless bolts, nuts and washers - no problems with leaks or rattles.
Kevin.
#3
Used to work here!!
Join Date: Jun 2000
Location: Peterhead, Scotland
Posts: 1,488
Likes: 0
Received 0 Likes
on
0 Posts
I think the instructions I got with my Maxnex centre was the tighten the bolts until there was a 10mm gap between the flanges all round the pipe
Stuart
Stuart
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM