Boost or gauge problem
#1
Used to work here!!
Thread Starter
Join Date: Jun 2000
Location: Peterhead, Scotland
Posts: 1,488
Likes: 0
Received 0 Likes
on
0 Posts
Just stuck a boost gauge (autometer) in but I think somethings wrong. At idle it sits about -20 but on the go I can't get it to go over about 5 psi, that was at over 4k revs in 4th gear with WOT before I ran out of road !! at 3k revs it was sitting at zero
Can anyone give me any pointers as to how it should read as I go up the rev range ?? It's a MY96
All the piping looks ok but I guess I may have a leak somewhere, I've T-eed off the centre of the 3 pipes.
Any thoughts ??
Can anyone give me any pointers as to how it should read as I go up the rev range ?? It's a MY96
All the piping looks ok but I guess I may have a leak somewhere, I've T-eed off the centre of the 3 pipes.
Any thoughts ??
#2
Scooby Regular
Join Date: Dec 2001
Location: Just far enough from sunny Liverpool
Posts: 6,963
Likes: 0
Received 0 Likes
on
0 Posts
Exactly the same thing happened to me with an autometer gauge, although mine didn't show any vacuum (usually around the -20). are you sure you are taking the boost feed from a stable source? check with chiarks siteas i think there are some photos there.
hope this helps,
simon
[Edited by RRH - 4/17/2002 11:17:56 PM]
hope this helps,
simon
[Edited by RRH - 4/17/2002 11:17:56 PM]
Thread
Thread Starter
Forum
Replies
Last Post