Uprated Driveshafts & CV's
#1
Scooby Regular
Thread Starter
Join Date: Jun 2009
Location: Salisbury
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
Uprated Driveshafts & CV's
Where would be the best place to go to for these?
Im running a 180 plated diff in my rear end, and the car is RWD, Ive gone through 4 shafts/cv's so far, ranging from the Type R RA, to the UK/JDM STI 8 stuff, have been looking all over for honest opinion on shafts, with reasonable pricing, as if I'm paying alot of money, i want to know its going to hold for pretty much forever!
Any advice guys?
Cheers.
Im running a 180 plated diff in my rear end, and the car is RWD, Ive gone through 4 shafts/cv's so far, ranging from the Type R RA, to the UK/JDM STI 8 stuff, have been looking all over for honest opinion on shafts, with reasonable pricing, as if I'm paying alot of money, i want to know its going to hold for pretty much forever!
Any advice guys?
Cheers.
#2
A mate is getting some made I will find out who off ,BTW he broke an "unbreakable shaft" one of a pair he bought from the states that came with a lifetime guaranteee ,the guarantee is no good when you've spent all the money on a rally and are stuck in a Welsh forest !!!
#3
THE braking specialist
iTrader: (259)
You can get GKN shafts which are pretty much unbreakable apparently , but at about £1200 each you would hope they would be.
They are probably ok with 4wd as the fronts are doing a lot of work , but with just RWD I wouldn't like to say
Check out these
http://www.subaruwrcspares.com/23.html
Cheers Ian
They are probably ok with 4wd as the fronts are doing a lot of work , but with just RWD I wouldn't like to say
Check out these
http://www.subaruwrcspares.com/23.html
Cheers Ian
Thread
Thread Starter
Forum
Replies
Last Post
hedgecutter
General Technical
3
25 September 2015 02:35 PM