How to fit ITG
#2
Scooby Senior
Join Date: Oct 2000
Location: Zurich, Switzerland
Posts: 3,105
Likes: 0
Received 0 Likes
on
0 Posts
Open airbox, remove paper filter, fit ITG filter, close airbox
It's a tight fit, make sure the wire mesh side is facing upwards....and pop it open after 4 weeks or so and clean the green gunk out of the bottom of the airbox.....
Richard
It's a tight fit, make sure the wire mesh side is facing upwards....and pop it open after 4 weeks or so and clean the green gunk out of the bottom of the airbox.....
Richard
#3
Leigh, be careful when fitting I have heard stories about the filter sliding down the housing as you replace the top cover, this creates a gap and can cause air turbulance probs, . It did this on my K & N filter Hold the filter in place as long as you can then you will get no probs
Frank.
Frank.
#4
I've just fitted one. Took about 5 mins. The only slightly difficult bit is getting the top cover back on - it needs to grab the 2 hooks on the bottom end before slipping over the front, where you snap the metal clips into place.
The fitting should be tight and neat, and I think the box will only close if you've fitted it correctly...
Goodluck!
The fitting should be tight and neat, and I think the box will only close if you've fitted it correctly...
Goodluck!
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM