Knock sensor location?
#3
Scott
There appears to be 3 sensors around the point where EJ20 is cast into the block just below the throttle linkage, is it one of these? There are 2 which are bolted into a cast aluminium pipe which leads to the radiator and there is one bolted straight down into the block with a large head on it. Which is the correct one if it is any of these?
Stuart
There appears to be 3 sensors around the point where EJ20 is cast into the block just below the throttle linkage, is it one of these? There are 2 which are bolted into a cast aluminium pipe which leads to the radiator and there is one bolted straight down into the block with a large head on it. Which is the correct one if it is any of these?
Stuart
#4
Scooby Regular
iTrader: (2)
Not sure Stuart, as mine is an MY94.
On mine the Knock sensor is almost directly below the throttle cable, is black, about the size of a 10p (but fatter) with the bolt going through the middle.
There is only 1 wire running to it, as I belive it's ground is via it's connection with the block.
On mine the Knock sensor is almost directly below the throttle cable, is black, about the size of a 10p (but fatter) with the bolt going through the middle.
There is only 1 wire running to it, as I belive it's ground is via it's connection with the block.
#5
it's above no.4 piston on every scoob can't miss it black round thing with the 12 mm bolt through the center. they did change the plug slightly so make sure you get the right one as they are not interchangeable with out dismanteling the plug
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM