problems with new clutch and flywheel
#1
problems with new clutch and flywheel
I have 2 problems... well 1, and 1 other question.
had fitted an exedy single plate organic clutch and Fidanze 4.4kg flywheel.
1st - there seems to be alot more clutch juddery going on, is this because i have fitted a 4.4kg flywheel and its a usual characteristic with a flywheel of that weight?
2nd - Problem - I've covered 30miles with the new clutch so far, peaking at 0.5bar boost only. when i coast with the car in gear i get a scratching rubbing sound. when i dip the clutch it goes, and when i accelrate it goes. Its only when i coast and i'm in gear. Could this go once its bedded in!? it covered 30 miles fine and now its only just started doing it. Anyone know what else it could be!?
had fitted an exedy single plate organic clutch and Fidanze 4.4kg flywheel.
1st - there seems to be alot more clutch juddery going on, is this because i have fitted a 4.4kg flywheel and its a usual characteristic with a flywheel of that weight?
2nd - Problem - I've covered 30miles with the new clutch so far, peaking at 0.5bar boost only. when i coast with the car in gear i get a scratching rubbing sound. when i dip the clutch it goes, and when i accelrate it goes. Its only when i coast and i'm in gear. Could this go once its bedded in!? it covered 30 miles fine and now its only just started doing it. Anyone know what else it could be!?
#2
Scooby Regular
iTrader: (7)
Join Date: Aug 2008
Location: North Walsham/FB Tuning
Posts: 1,142
Likes: 0
Received 0 Likes
on
0 Posts
the clutch judder will be because the exedy organic plate is to hard i had the same probley on my car so i changed the clutch plate to a stand exedy one and then i got no probley at all talk to zen performace and thay will let you know wot to do ok 01933675432
#3
you should not need to bed it in.
when api skimmed my flywheel and fitted a exedy organic clutch it was as smooth as butter right from the off. i hasd terrible judder before
when api skimmed my flywheel and fitted a exedy organic clutch it was as smooth as butter right from the off. i hasd terrible judder before
#4
Scooby Regular
iTrader: (1)
Join Date: Feb 2006
Location: Warwickshire, UK
Posts: 2,099
Likes: 0
Received 0 Likes
on
0 Posts
Scratching sound sounds like the release bearing to me, you shouldn't get normal judder, although a light flywheel will give some 'judderiness' at low engine speed, sounds to me like you have a duff install.
Simon
Simon
Thread
Thread Starter
Forum
Replies
Last Post
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM