Has Any 1 fit a pipercross induction kit to there scooby? UK ver i have '97, if so was it an easy job?, i am looking at the instructions at the moment and already i have a problem with it

 

What is the problem?

MD.

 

all the stuff is numbered i.e. pipes to remove connect etc, untill 1 point when it says connect air sensor pipe (11) but there is no fig 11 shown on the diagram, and i am no expert on this car (

 

To be honest, I cant help you with the diag cos I havn't got them any more.

I would have thought that once you start fitting the bits it will be obvious where it all goes...mine is a MY99 so it is different.

I do remember a small vacuum (?) pipe which connects to the new aluminium "hose" via a small dia welded on spigot.

Anyway, good luck.

MD.

 

hiya m8 its fitted now did not need the alluminium housing, the fooking diagram they sent was for a WRX i know coz my m8 come round with his WRX and thje diagram engine bays was his , mine is different, but hey its on ok n/p

 

OK

 

mind u dude if u check my other thread i could use some advice, i am worried