OcTag3n

iTrader: (4)

Hi all,

Got in my car this morning to come to work, started it up & tried to get it into reverse but it wouldn't go in. 1st no good, 2nd, 3rd, in fact all gears wouldn't select.
It felt like my clutch wasn't disengaging all the way.

I've just fitted an intercooler water spray & was wondering if the water that has run through the intercooler whilst I was setting it up has got onto the clutch release arm, which has made it stick in some way. It eventually slotted into reverse & off I drove but the car has never done this before.

Any other ideas like maybe a sticking clutch release bearing?

Thanks.

steveorangewrx

I would try bleeding the clutch line as the fluid may be contaminated, although it would be strange as the system is obviously sealed.

Butty

iTrader: (2)

Did you run any hoses or wiring for the IC spray anywhere near the clutch pedal?

Nick

OcTag3n

iTrader: (4)

No I checked that & the hose is no where near the clutch pedal mechanism.

andyxros

had same problem with mine 2 days ago peddle felt normal but no gears i just held peddle down and flicked foot off so it came up fast and not had anything since. just come on hear to see if i have to save up for anything if its a cause for problem in future but not found anything yet fingers crosed

andyxros

thinking about it now i did wash car 2 days before with hose pipe and washed a lot of water down scoop and didnt drive it for the 2 days so water might if got in there some how and rusted a bit causing it to stick a bit???