morpheous

iTrader: (9)

Does anyone know without me taking off and measuring if the front driveshafts are the same length etc:
Also are the splines on the outer cv joint to hub uk/jdm the same ?

GariYaRally

Left and right are different lengths. The right is slightly longer. I think you'd need to take them off, only way 'I' know is to bush inner and outer CV towards each other to deduce which is longer.
uk/jdm splines are the same.......

morpheous

iTrader: (9)

Cheers for the reply i knew they would have to come lol.
I have a pair here and have tried checking the lenghts but they both look the same thats why i asked the question,oh well off to work we go

GariYaRally

push both ends of the drive shaft to each other, there will defo be a difference. Stand them up against each other and push them down from the CV...........

morpheous

iTrader: (9)

How much difference we talking ?

GariYaRally

not alot, but see-able difference. We had a problem with this with the pre-prodrive grp A legacys, driveshaft popped out a number of times until the difference was known.

morpheous

iTrader: (9)

Cheers matey will take them off and measure properly,have tried again side by side and they look the same ? Unless theyre both from the same side

GariYaRally

Put 'em so that they're standing vertically next to each other, with diff end at the bottom. Push down on the cv's via the splined end, downwards. You should then see the difference in length