stuck getting clutch bearing cross shaft
#1
stuck getting clutch bearing cross shaft
Hi im stuck getting the clutch shaft out i have screwed the m6 bolt it and it won't budge is there a trick to get it out or is it just persavence.
#2
Scooby Regular
Join Date: Sep 2000
Location: Deepest Darkest Dorset!!
Posts: 10,011
Likes: 0
Received 1 Like
on
1 Post
Mmm, not quite sure what you've done, so,..... once you've removed the allen key bolt, there's a shaft in the hole with a threaded hole in the middle, find a suitable bolt, wind the bolt in, and usually the shaft comes out without too much grief...... hopefully you'll have got it out by now anyway!
#3
WD40!
Remove the rubber boot over the clutch release arm and spray a LITTLE in there too. Have a cup of tea to allow it to soak and force the bugger out pulling/levering on the m6 bolt (screw it well into the shaft!)
Graham.
Remove the rubber boot over the clutch release arm and spray a LITTLE in there too. Have a cup of tea to allow it to soak and force the bugger out pulling/levering on the m6 bolt (screw it well into the shaft!)
Graham.
#5
thanks for the help thought everything was going to well it was flying off untill i got to this point. was feeling worse for wear with the beer today so that could be why I was finding it hard.
#6
still no luck can you buy a tool to get it out? or am I just going to have to keep trying? also what size nails do you need to knock the pins out of the driveshafts.
#7
Scooby Regular
Join Date: Nov 2003
Location: MY02 WRX w/ Ver8 STi engine & 6MT
Posts: 617
Likes: 0
Received 0 Likes
on
0 Posts
If they are stubborn, I use a decent size washer and a door panel trim removal tool. It looks like a screwdriver but the end has a V shape to it. Its also bent on the end to help you get leverage. Just keep at it, you'll get it out.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM