phill 147

recently had a clutch fitted and it all seems to work ok but when you are driving there is a vibration on the clutch pedal but this goes when you push pedal down?

also how do you adjust the clutch pedal as it seems high?

911

Firstly, it all works so do you really want to mess with it?
Secondly, the vibration will be the thrust bearing, and will either continue to do it and last forever or will bed in a bit. i wouldn't worry.

As to the adjustment:

You first need to check if there is about 10mm of free play at the pedal where you press your foot. If there is then all is well.
The adjustment is right under the dash. You may need to remove the dash undertray unless you are Houdinie (spelling..).
The adjusting nut is where the rod goes from the pedal operating arm through the bulkhead into the master cylinder for the clutch.

Graham.

flat4

it will bed in, i adjusted my pedal only to have to adjust it back a week later