power increase?
#1
Scooby Regular
Thread Starter
Join Date: Feb 2005
Location: 250/ton ;-)
Posts: 503
Likes: 0
Received 0 Likes
on
0 Posts
power increase?
iv got an MY95 WRX which was last rolling roaded at 276bhp@flywheel with exhaust, downpipe, decat.
Iv only owned it a couple of weeks, but it has a crappy slanty intercooler on it, and a K&N that looks like its 10 years old which i imagine arent doing it any favours!
Iv got an sti5 intercooler sat here waiting to go as well as a standard airbox, and an sti panel filter is on order from stiracing. I was also thinking of an uprated fuel pump, and a remap.
just out of interest, would you imagine that this lot would see it over 300bhp?
Iv only owned it a couple of weeks, but it has a crappy slanty intercooler on it, and a K&N that looks like its 10 years old which i imagine arent doing it any favours!
Iv got an sti5 intercooler sat here waiting to go as well as a standard airbox, and an sti panel filter is on order from stiracing. I was also thinking of an uprated fuel pump, and a remap.
just out of interest, would you imagine that this lot would see it over 300bhp?
#2
Scooby Regular
iTrader: (15)
Join Date: Jul 2001
Location: Portsmouth
Posts: 8,606
Likes: 0
Received 0 Likes
on
0 Posts
no would be the simple answer, but you cant draw figures out of the air like that.
look into the projects section for Carl Davey's 300 quest.
a spec list a lot bigger than yours and he fell short, with a bit of fettling he made the numbers.
look at Bobs quest for similar power.
At current pricing it seems to take 2 grand to get 300 brake
look into the projects section for Carl Davey's 300 quest.
a spec list a lot bigger than yours and he fell short, with a bit of fettling he made the numbers.
look at Bobs quest for similar power.
At current pricing it seems to take 2 grand to get 300 brake
#3
Scooby Regular
iTrader: (27)
Join Date: Feb 2004
Location: Cheshire
Posts: 1,597
Likes: 0
Received 0 Likes
on
0 Posts
i got 317 bhp at prosport running 19 psi - wasnt healthy for it, bad detting - bigger injectors required and apexi power fc on the way next!
the current engine spec thow:
scooby ecu @ 15.5psi on optimax (Z4 ecu) (used HKS FCD & manual boost for above r.road)
HKS induction kit (custom heat shield and cold air feed)
hks downpipe
scoobyworld centre & afterburner angled backbox
new coil packs & NGKpfr7bs
full samco's
walbro fuel pump
So anyones guess as the power - i would guess at 280/290 if im lucky
on above mods and that lot cost a fortune and only scratching the top of mods!!!
tim
the current engine spec thow:
scooby ecu @ 15.5psi on optimax (Z4 ecu) (used HKS FCD & manual boost for above r.road)
HKS induction kit (custom heat shield and cold air feed)
hks downpipe
scoobyworld centre & afterburner angled backbox
new coil packs & NGKpfr7bs
full samco's
walbro fuel pump
So anyones guess as the power - i would guess at 280/290 if im lucky
on above mods and that lot cost a fortune and only scratching the top of mods!!!
tim
Thread
Thread Starter
Forum
Replies
Last Post
jobegold@hotmail.co.uk
ScoobyNet General
2
27 September 2015 09:44 PM