DeanF

iTrader: (1)

Hi, going to fit my AFR gauge this weekend & was hoping somebody could point me in the right direction for the Lambda sensor wire @ the ecu , or point me in the direction of a diagram for the pinouts etc.

Is the common practice for fitting this to bare the wire & solder to the wire on the ecu or to join with conectors ??
Thanks

Dean

tweenierob

Solder is your best bet mate, so a serch for 'ecu pin outs and that will give you a link to what you need. Do yourself a favour and check everything works ok before soldering.
Take the signal from eth wire as close to the ECU as you can adn earth the gauge to the frame of the ecu.

The earth wire seems to be the most imporatnt thing, most of the problems people have with fitting AFR gauges comes down to poor/incorrect earthing.

Rob

DeanF

iTrader: (1)

Cheers rob, Is this the correct diagram, says for MY96 WRX

http://www.ravensblade-impreza.com/m.../my96ecu-1.gif

Hmm , Link will have to be pasted into internet explorer due to not allowing hot linking
Dean