View Poll Results: What boost should I run?
Reduce to 0.95 bar
0
0%
Reduce to 0.9 bar
0
0%
Reduce to 0.85 bar
0
0%
Reduce to 0.8 bar (standard)
0
0%
Voters: 3. You may not vote on this poll
MBC + Boost levels
Thread Starter
Scooby Regular
Joined: Feb 2004
Posts: 615
Likes: 0
From: Dubai
MBC + Boost levels
I've just fitted a MBC and boost gauge to my MY99 JDM Forester.
Shortly I'll be putting on a decat downpipe but I don't plan a remap until later in the year (September/October).
I've set the boost level to a max of 1 bar.
Is this safe or should I reduce it.
Please vote above.
Shortly I'll be putting on a decat downpipe but I don't plan a remap until later in the year (September/October).
I've set the boost level to a max of 1 bar.
Is this safe or should I reduce it.
Please vote above.
Last edited by gavnnik; May 6, 2004 at 10:16 PM.
Thread Starter
Scooby Regular
Joined: Feb 2004
Posts: 615
Likes: 0
From: Dubai
Surely if I cut the max boost back to the 0.8 bar it was running prior to installation then I've restored the status quo.
These mods were recommended by API engines with no mention of a knocklink, I've just decided to do it myself.
Incidentally is there and alternative to the knocklink as it (IMHO) fugly (althought as pointed out better then a knackered engine).
These mods were recommended by API engines with no mention of a knocklink, I've just decided to do it myself.
Incidentally is there and alternative to the knocklink as it (IMHO) fugly (althought as pointed out better then a knackered engine).
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM
