Turbo Inlet Baffle - A question
#1
On the left hand side of my 94 WRX bonnet scoop, a section leads to the top of the turbo inlet (For ramair?). On the underside of the bonnet there is a metal baffle or restrictor that marries up with the turbo inlet.
Can this be safely removed, or replaced by an aftermarket product to allow a greater flow of air into the turbo? Thus increasing the Ramair effect, and hence power, response etc etc..
My spanners are at the ready, or should I put them back in the box?
Can this be safely removed, or replaced by an aftermarket product to allow a greater flow of air into the turbo? Thus increasing the Ramair effect, and hence power, response etc etc..
My spanners are at the ready, or should I put them back in the box?
#2
Al
Put them back in the box , the inlet next to the scoop allows cool air to pass over the turbo. As you can imagine the turbo will get very hot. The scoop just direct air flow over the turbo to help in the cooling.
Cheers
Yee
Put them back in the box , the inlet next to the scoop allows cool air to pass over the turbo. As you can imagine the turbo will get very hot. The scoop just direct air flow over the turbo to help in the cooling.
Cheers
Yee
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM
MH-Racing
Subaru Parts
18
18 October 2015 04:49 PM