AM I DYING???
06 February 2001, 10:00 PM
#1
Scooby Regular
Thread Starter
Join Date: Jan 2001
Posts: 5,582
Likes: 0
Received 0 Likes
on
0 Posts
Sorry I know the title is a bit sensational!I've recently noticed that on a cold start up my idle speed is irregular,it keeps alternating between 800 and about 1300rpm until it warms up.Does this mean anything sinister?(spec:STi4 13k miles, HKS inuction kit,SuperDrager recently removed,recently serviced).All thoughts would be appreciated.
07 February 2001, 11:46 AM
#2
Scooby Regular
Join Date: May 2000
Location: MY00,MY01,RX-8, Alfa 147 & Focus ST :-)
Posts: 10,371
Likes: 0
Received 0 Likes
on
0 Posts
DS
If it settles down once warm, then I don't believe this is a big problem. You can adjust the idle speed, using the idle speed controller, located on the throttle body between the intercooler and the inlet manifold. Speak to Pete Croney at Scoobysport, who I know has advised on this before.
Chris
[This message has been edited by Chris L (edited 07 February 2001).]
If it settles down once warm, then I don't believe this is a big problem. You can adjust the idle speed, using the idle speed controller, located on the throttle body between the intercooler and the inlet manifold. Speak to Pete Croney at Scoobysport, who I know has advised on this before.
Chris
[This message has been edited by Chris L (edited 07 February 2001).]
07 February 2001, 04:13 PM
#4
Scooby Regular
Thread Starter
Join Date: Jan 2001
Posts: 5,582
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Chris,I'm going to SS soon so I'll show it to them then.
I took of the SD only two months after buying it because it was just too loud to cope with on a day to day basis.Have lost quite a bit of top end power
I took of the SD only two months after buying it because it was just too loud to cope with on a day to day basis.Have lost quite a bit of top end power
Thread
Thread Starter
Forum
Replies
Last Post
charlesr
Engine Management and ECU Remapping
7
26 September 2015 10:46 AM
Adam Kindness
ScoobyNet General
0
15 September 2015 03:31 PM