David L

Probably a stupid question but how do you check the rear diff oil level and fill it up if needed? Do you remove one of the nuts and see if the oil comes out??

David L

GrahamF

When you look at the diff end plate there should be four round the outside holding the plate on and two bigger ones towards the centre. The top one's the filler hole, ie fill 'til the oil dribbles out. The book says API class GL-5 SAE 85W for this country.

Graham

JohnD

iTrader: (5)

David
As Grahame said use GL5 75w/90 but make sure it is limited-slip compatable! E.G. Valvoline GL5-LS If your car is not new it might be worth considering a diff. oil change. Its simple!
Cheers JohnD

David L

Graham,
Does that mean you take out the bottom nut and fill through the top hole until the oil runs out the bottom nut.

David L

russell hayward

NO !!

The bottom nut is drain only.

Drain, refit the lower nut, then refill through the upper hole until the oil just starts to run out of the upper hole.

Oooh er .......................

David L

Thanks for the info. Russell..

David L