Notices
Drivetrain Gearbox, Diffs & Driveshafts etc

Engine won't run over tickover.

Thread Tools
 
Search this Thread
 
Old 13 October 1999, 06:16 PM
  #1  
Mike Tuckwood
Scooby Regular
Thread Starter
 
Mike Tuckwood's Avatar
 
Join Date: Jan 1999
Posts: 2,694
Likes: 0
Received 0 Likes on 0 Posts
Question

My car has decided to play up.

I started it this morning, drove 1 mile down the road and it felt as if it was running out of fuel, then the engine cut out completely.

Parked up the engine will start perfectly, runs for about 5 seconds then stops again as if it has had the fuel cut off?

The speedo cable is not connected as I was just about to fit the reduction gearbox and had pulled it out of the back of the speedo.

I dis-connected the fuel pipe and turned on the ignition, a strong flow of petrol came from the filter to fuel rail pipe.

It's now been transported to C&K via low loader.

Any ideas as to the probable cause?

Mike.
Old 13 October 1999, 09:03 PM
  #2  
LEE.R
Scooby Regular
 
LEE.R's Avatar
 
Join Date: Sep 1999
Posts: 96
Likes: 0
Received 0 Likes on 0 Posts
Post

If you havent got the cable connected the car will not run the ecu gets confused as there is no information getting back from the speedo dont no the technical but mine did the same until I put the cable back on.You may have wasted a trip to ck.My moto is if it runs fine before work then after it dosnt chances are that is where to look first
Old 13 October 1999, 11:04 PM
  #3  
DAZ
Scooby Regular
 
DAZ's Avatar
 
Join Date: Sep 1999
Posts: 213
Likes: 0
Received 0 Likes on 0 Posts
Cool

mike your stereo is drinking your fuel now
:-)

what alarm system have you got i had a similar problem with mine and it was the fuel cut off on the alarm there was not enough signal to allow it to arm (clifford 600)
Old 13 October 1999, 11:28 PM
  #4  
firefox
Scooby Regular
 
firefox's Avatar
 
Join Date: Feb 1999
Posts: 1,821
Likes: 0
Received 0 Likes on 0 Posts
Cool

Mike...oh Mike.... Oh Mike...

J.
Old 14 October 1999, 10:04 AM
  #5  
Mike Tuckwood
Scooby Regular
Thread Starter
 
Mike Tuckwood's Avatar
 
Join Date: Jan 1999
Posts: 2,694
Likes: 0
Received 0 Likes on 0 Posts
Talking

Thanks Jay, that was just what the doctor ordered.

Car went by low loader at 4pm yesterday, (approx 2 hour trip). Received this reply from Peter this morning.

The trip wasn't wasted, I was going up there on Saturday anyway to exchange my mild steel twin dump pipe for a HPC coated one and to get the wastegate actuator replaced.
<I>From Peter @ C&K</I>
>MIKE, the cars now running,the speedo wasnt connected the select monitor
picked that up.the pipe was off the fuel pressure regulator this may of
happened when you were under the bonnet.the car is now boosting to 1.4 then
holding 1.2 bar with a new waste gate actuator,will look at the ecu and check
the codes again in the morning.
peter.

Now that's what I call service!

Mike.
Old 14 October 1999, 11:13 AM
  #6  
firefox
Scooby Regular
 
firefox's Avatar
 
Join Date: Feb 1999
Posts: 1,821
Likes: 0
Received 0 Likes on 0 Posts
Cool

Soz dude...

Shouldnt have been so nasty..

I could have told you about the speedo... oh well...

Glad to see you have a new actuator fitted..and holding a reasonable level of boost... lol

And the new pipe... you're car will be back on the road in a big way!!

I'm stiiiiiiiiiiillllllllll waiting for my bits.. chances are I will be in the Tractor for the meet.. oh well....

J.
Old 14 October 1999, 11:13 AM
  #7  
Craig H
Scooby Regular
 
Craig H's Avatar
 
Join Date: Jun 1999
Posts: 770
Likes: 0
Received 0 Likes on 0 Posts
Post

Mike,
May have gone over this before. What's been done to yours to hold 1.2bar?
You lucky Bstd.

Cheers

Craig
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
oilman
Trader Announcements
15
01 October 2015 11:55 AM
ALi-B
Other Marques
18
28 September 2015 08:29 PM
bugeye269
General Technical
2
27 September 2015 11:05 PM



Quick Reply: Engine won't run over tickover.



All times are GMT +1. The time now is 02:40 AM.