De-cat advice please
Having just picked up my new car (Sti5 Type R) I'm looking at upgrading the centre section only to get rid of the cats without increasing the noise level too much.
Can anyone give me any suggestions as to which one to go for?
Thanks
SS23.
Can anyone give me any suggestions as to which one to go for?
Thanks
SS23.
AFAIK but if you remove the cats you will get a slightly louder exhaust note depending on your back box of course! If its a standard then i cant see it being anything out of the ordinery volume wise, just bit deeper i reckon.
I have a HKS d/pipe and straight onto a jap system with no cat but it is still quite quiet because i have found that they installed an extra expansion chamber near the rear, before the back box to help quiet the sound. So sod that! im saving for a blitz system and a 3" 2nd decat pipe to connect the blitz to me HKS 3" d/pipe now that will be loud!!!!!!
You will notice that the car is also a bit more responsive too!
Hope this helps!
I have a HKS d/pipe and straight onto a jap system with no cat but it is still quite quiet because i have found that they installed an extra expansion chamber near the rear, before the back box to help quiet the sound. So sod that! im saving for a blitz system and a 3" 2nd decat pipe to connect the blitz to me HKS 3" d/pipe now that will be loud!!!!!!
You will notice that the car is also a bit more responsive too!
Hope this helps!
Former Sponsor
iTrader: (4)
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
STi 5 doesn;t have a cat in the centre section..
there is only one cat in the downpipe..
You could change this and the noise increase if you wrapped the pipe with exhaust wrap would be not too much.
Need to watch issues with fueling though being an import.
You might be better going for a ECUTek 3
JGM
there is only one cat in the downpipe..
You could change this and the noise increase if you wrapped the pipe with exhaust wrap would be not too much.
Need to watch issues with fueling though being an import.
You might be better going for a ECUTek 3
JGM
Thread
Thread Starter
Forum
Replies
Last Post
Phil3822
General Technical
0
Sep 30, 2015 06:29 PM



