Power Engineering STi8 Fuel Pump
#1
Does anyone know anything about Power Engineering's uprated fuel pump kits for the STi7/8?
More specifically:
Are these drop in replacements for the OE pump?
Do they have all the functionality of the OE pumps? (eg. do they cater for varying voltage levels).
What are the cons of installing one of these pumps without doing a remap?
Then, the clincher, is it true that these are the same pumps supplied to Prodrive?
More specifically:
Are these drop in replacements for the OE pump?
Do they have all the functionality of the OE pumps? (eg. do they cater for varying voltage levels).
What are the cons of installing one of these pumps without doing a remap?
Then, the clincher, is it true that these are the same pumps supplied to Prodrive?
#2
Bruce not sure about the Power Engineering Fuel Pumps as I don't know what models they use. The general upgrade path is to use the intank / direct replacement walboro units rated at 255 l/h. Shouldn't need to remap if this is the only part you are changing because its not changing the pressure. If youre not going to remap or do further mods then there isn't much point in fitting one.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM
DogsofWar
Engine Management and ECU Remapping
16
23 September 2015 07:41 PM