Simple silly question
12 September 2003, 04:13 PM
#1
Scooby Regular
Thread Starter
Join Date: Apr 2003
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
I'm not sure of the size, however you can get copper washers that have small holes in but have quite large flanges (Oh err). I use these on most things, as I just drill out to the required diameter. This is if you don't get the required answer before halfords shuts.
.
09 December 2003, 02:17 PM
#6
Drag it!
iTrader: (1)
Join Date: Jun 2002
Location: Flame grilled Wagon anyone?
Posts: 9,866
Likes: 0
Received 0 Likes
on
0 Posts
The copper washers for the turbo water feed and return, what size are they, and should i be able to buy some or a selection from a Halfords Store?
I have been fiddling with the car, and their now appears to be a white smoke from around the turbo area, but only when i have given it some pedal, ie increased pressure, and the smoke is short lived.
So, as i have had the water pipes off, i am assuming its the copper washers, and shall replace those.
Cant feel any water on idle (burns hands
) or once the engine is cold, so assume its coming out under extreme pressure and just evaporating.
Steven
[Edited by P20SPD - 9/12/2003 2:30:00 PM]
I have been fiddling with the car, and their now appears to be a white smoke from around the turbo area, but only when i have given it some pedal, ie increased pressure, and the smoke is short lived.
So, as i have had the water pipes off, i am assuming its the copper washers, and shall replace those.
Cant feel any water on idle (burns hands
) or once the engine is cold, so assume its coming out under extreme pressure and just evaporating.Steven
[Edited by P20SPD - 9/12/2003 2:30:00 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM
Phil3822
General Technical
0
30 September 2015 06:29 PM