fitting boost gauge to 98 UK Turbo
29 August 2003, 08:00 PM
#1
Scooby Regular
Thread Starter
Join Date: Oct 2002
Location: North Staffs. UK
Posts: 2,046
Likes: 0
Received 0 Likes
on
0 Posts
Where's a good place to take the boost level from for a mech. gauge ?
I've included this piccy, as there appears to be a stopper of some kind on a possible candidate ...
Or should I use the T-Piece (Where into >
Cheers,
Mark
[Edited by markwild - 8/29/2003 8:01:10 PM]
[Edited by markwild - 8/29/2003 8:02:43 PM]
I've included this piccy, as there appears to be a stopper of some kind on a possible candidate ...
Or should I use the T-Piece (Where into >
Cheers,
Mark
[Edited by markwild - 8/29/2003 8:01:10 PM]
[Edited by markwild - 8/29/2003 8:02:43 PM]
01 September 2003, 07:17 PM
#4
Scooby Regular
Thread Starter
Join Date: Oct 2002
Location: North Staffs. UK
Posts: 2,046
Likes: 0
Received 0 Likes
on
0 Posts
Hmm, fitted, but buzzes !
Spoke to Jamie at JWR and I've missed the Y Piece out - but I've no instructions...
Any clue to how to fit ?
Mark
Spoke to Jamie at JWR and I've missed the Y Piece out - but I've no instructions...
Any clue to how to fit ?
Mark
02 September 2003, 07:13 PM
#6
Scooby Regular
Thread Starter
Join Date: Oct 2002
Location: North Staffs. UK
Posts: 2,046
Likes: 0
Received 0 Likes
on
0 Posts
Its an AVO gauge - Take a look at my thread above, sounds like the buzzing is correct, when no restrictor is fitted.
Any ideas to the position of this would be most welcome....
Mark
Any ideas to the position of this would be most welcome....
Mark
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM