Trying to remove the clutch pivot arm pin
#1
Scooby Regular
Thread Starter
Join Date: Jul 2003
Location: Staffordshire
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
I am trying to remove my clutch pivot arm pin on a 94 wrx!
i have tried to wind a 6mm bolt through but its snapped off! Has anyone got a picture of the arm assembly as this will be a great help!? or any suggestions??
i have tried to wind a 6mm bolt through but its snapped off! Has anyone got a picture of the arm assembly as this will be a great help!? or any suggestions??
#4
Scooby Regular
Join Date: Mar 2002
Location: Fcon Power Writer
Posts: 4,338
Likes: 0
Received 0 Likes
on
0 Posts
Lol either that or smash the bell housing to bits with a big hammer
Seriously though, if you can get hold of another release bearing you can pull the box off by bending the tabs on the bearing.
It is hard but i have done it, the arm is much stronger than the bearing tabs.
Rob
Seriously though, if you can get hold of another release bearing you can pull the box off by bending the tabs on the bearing.
It is hard but i have done it, the arm is much stronger than the bearing tabs.
Rob
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM