I am trying to remove my clutch pivot arm pin on a 94 wrx!
i have tried to wind a 6mm bolt through but its snapped off! Has anyone got a picture of the arm assembly as this will be a great help!? or any suggestions??

all you should do is wind in a bolt "finger tight" and ease out!!
not sure what you'll do now if you can't draw the pin.....
alyn - asperformance.com

hmm Suggest you weld a nut to it now!

David

Lol either that or smash the bell housing to bits with a big hammer :D:D

Seriously though, if you can get hold of another release bearing you can pull the box off by bending the tabs on the bearing.
It is hard but i have done it, the arm is much stronger than the bearing tabs.

Rob