SPARK PLUGS
#1
Do you have a boost gauge fitted? .... you will need one to set the Dawes .... other than that no, you can just fit them and away you go.
Not sure if you need to run different plugs though with a Dawes, might be wise as the boost will be higher.
Hopefully someone can give you advice on that. I run HKS iridiums but thats on a custom remap and full decat etc.
Gary
[Edited by LB4 - 7/2/2003 12:06:41 AM]
Not sure if you need to run different plugs though with a Dawes, might be wise as the boost will be higher.
Hopefully someone can give you advice on that. I run HKS iridiums but thats on a custom remap and full decat etc.
Gary
[Edited by LB4 - 7/2/2003 12:06:41 AM]
#2
Have slightly modded uk my96(dawes,centre decat,itg panel,afterburer back box)Has anyone any plug recommendations? Also have not yet fitted centre decat,dawes or itg,are they just plug and play?Do i need to do anything else when i do these mods,as am planning for same day install then service.Any help much appriciated, Cheers jamie
#4
No a knocklink is only to give a visual warning of det/pinking/knocking .... it will not tell you what boost you are running.
I understand what you are saying though, slowly turn the Dawes up until you start to see an increase on the knocklink then back it off a bit.
Thats your choice of course but IMO its better to have a guage and the knocklink.
Gary
I understand what you are saying though, slowly turn the Dawes up until you start to see an increase on the knocklink then back it off a bit.
Thats your choice of course but IMO its better to have a guage and the knocklink.
Gary
Thread
Thread Starter
Forum
Replies
Last Post