I would like to see (please post here)some fotos of the MRT Inlet/ Intake pipe whit APS Intake system and OEM MAF sensor of the MY00 car all fitted and whitout troubles.......

Many Thanks

 

havnt got any photos but i fitted this setup to my p1 and it all went on without any dramas.it was fitted by roger clark motorsport.only hickup is the breather pipe from the engine(the short one just before the turbo inlet)u hve to extend this using a joiner to reach the return on the inlet pipe which is near the rear of the maf.u will also need a bung to go in the top hole..if u want pics i will try to find my post showing them in members gallery under myp1..this will alter/increase the airflow..i obtained stronger and higher boost from this set up.what ecu are u running
sorry found post but pics have gone missin

[Edited by myp1 - 4/21/2003 7:36:58 AM]

 

Hmm, had one, not sure where it's gone (the picture, that is ). It does all fit, though, but a bit tight! I think John B has that set-up? (I don't use the MAF, although I do still use the MAF housing).
I'm hoping that a remap is 'on the cards' here as well, as these two together change the airflow significantly?

 

If you can please take some fotos and post here ;-)

Thanks