zetec in fiesta turbo
#1
does anyone know how or what is needed to fit a 2.0 ford zetec engine in a fiesta turbo my mate plans on fitting the original head from the fiesta engine to the zetec any info would be appreciated ...ta
#4
Scooby Regular
Join Date: Mar 2002
Location: Fcon Power Writer
Posts: 4,338
Likes: 0
Received 0 Likes
on
0 Posts
Only in my head i'm afraid..
There is a waterway behind cylinder one and four that are not present in the CVH head.
You can either fit the head straight on and the gasket will seal it(not reccomended) or (dare i say this..) i used chemical metal
There is also a locating dowel that must be removed on the block.
IIRC the standard RST timing belt was two teeth short so a Custom belt is needed.
Low boost!!!!!!!! high compression!!!
Rob
There is a waterway behind cylinder one and four that are not present in the CVH head.
You can either fit the head straight on and the gasket will seal it(not reccomended) or (dare i say this..) i used chemical metal
There is also a locating dowel that must be removed on the block.
IIRC the standard RST timing belt was two teeth short so a Custom belt is needed.
Low boost!!!!!!!! high compression!!!
Rob
Thread
Thread Starter
Forum
Replies
Last Post