Exhaust Fitting
#1
How hard is it to remove the standard backbox from MY00 and then put another one on. Ive just bought a P1 exhaust of bbs and dont want to have to pay someone to fit it. Any advice would be very welcome,
Cheers
Chris
Cheers
Chris
#2
Scooby Regular
Join Date: Feb 2001
Location: Hemel Hempstead
Posts: 7,953
Likes: 0
Received 0 Likes
on
0 Posts
Simple, very simple. The BB has two hangers at the rear and another hanger near the back of the silencer..... its joined to the center by two nuts/bolts, undo the nuts and bolts, take BB of hangers..... easy.
Refit is a reversal of removal, I find it easier to put the BB on the rear hanger, do up the nuts then put on the reat two hangers.... clean up the flanges with a wire brush and use a gasket/paste to make sure of a good joint.
15min job.
Refit is a reversal of removal, I find it easier to put the BB on the rear hanger, do up the nuts then put on the reat two hangers.... clean up the flanges with a wire brush and use a gasket/paste to make sure of a good joint.
15min job.
#3
Cheers for the help, sounds easy enough.
One last question and please understand I am a novice but what do I ask for in the shop when it comes to gasket/paste, will they know what I mean and presumably I dont need to go to Subaru?
Thanks again,
Chris
One last question and please understand I am a novice but what do I ask for in the shop when it comes to gasket/paste, will they know what I mean and presumably I dont need to go to Subaru?
Thanks again,
Chris
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
KOEScoob
ScoobyNet General
6
17 September 2015 03:51 PM