Changing Boost Pipes
#1
Further to my post yesterday I have noticed that one of the hoses is badly split. This is the one coming off the top of the engine. The section as it joins the t-piece is badly split.
As a short term solution I have zip tied it and it seems to be holding.
Obviously this is not a long term solution.
When changing the length of hose can anything that size be used or does it need to be a special fitting?.
Thanks
As a short term solution I have zip tied it and it seems to be holding.
Obviously this is not a long term solution.
When changing the length of hose can anything that size be used or does it need to be a special fitting?.
Thanks
#2
As long as it's capable of holding the pressure & is a good seal - it should be fine.
Personally - I'd recommend a silicon pipe as an alternative.
Regards,
Chris
[Edited by Chris.Palmer - 3/29/2003 10:05:12 PM]
Personally - I'd recommend a silicon pipe as an alternative.
Regards,
Chris
[Edited by Chris.Palmer - 3/29/2003 10:05:12 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM