Can somebody please advice just bought a hks hiper exh. the boost in 1st 0.5 bar just don't want to 1 bar, can someone please help.


JAK

 

I kow I have been drinking, and you are from Brum but I am sure that your post is not in english enough for me to understand?

You are getting 0.5 but were getting 1bar before exhaust mod??

Try resetting the ECU... Look here to see how

JGM

 

Sorry about my english I was abit drunk earlier on anyway the problem is that with my old exhaust I didn't have any boost problems.
The new HKS Hiper I Just can't get it go to 1 Bar it will only go far has 0.5Bar can please help?

JAK

 

Sounds like you need to check the ECU error codes.

look under the dash near the steering column and you'll see the wiring loom.. look for four plugs.. two are green and two are black. They have one wire coming out of each plug and may be tapes back if never used before.

Connect the two black together and turn the ignition on but don't start the engine and the check engine light should flash any history there is.. see the website linked in my other post above to decode the code history.

Once you have seen the code and resolved the problem, or if there is no problem reset the ecu by connecting both green and black together and turn the ignition on.. press ignition to the floor, and then lift to half throttle.. hold it for 3seconds and then start the engine and drive it like normal for a few minutes and the check engine light should flash acknowledgement.

JGM

 

the link u have for the fault code dont work could u send the page instaed plz

 

JAK you W****ker, you been using my account again!!!

no wonder my old password does not work.

Anyway the real rayman has sorted JAKs problem. Use english you making me look bad here...you muppet.