Fitting SFC multi HELP!!!!!
#1
Scooby Regular
Thread Starter
Join Date: Oct 2002
Location: Leeds
Posts: 457
Likes: 0
Received 0 Likes
on
0 Posts
Hello All,
I'm going to attempt to fit a field sfc multi, just a few questions for the wise.
1.On the back of the unit there is 6 small switches what position should they be in? (This unit came out of a 300zx and was set with every switch up apart from n.6, so this leads me to believe its related to the cylinders)
2.there is five wires coming from the unit 2 black (earth), 1 red(+), 1 orange (?), 1 brown (?). When i took it out of the 300zx the orange and brown were connected to the ecu via bullit connectors inbetween a thick white wire. Where do i connect the orange and brown to on the scoob? or what information do they need?
3.Last but not least the 3 ajustments on the front low,med,high, where should they be set?
Any help is much needed,
Many thanks in advance,
Andi
I'm going to attempt to fit a field sfc multi, just a few questions for the wise.
1.On the back of the unit there is 6 small switches what position should they be in? (This unit came out of a 300zx and was set with every switch up apart from n.6, so this leads me to believe its related to the cylinders)
2.there is five wires coming from the unit 2 black (earth), 1 red(+), 1 orange (?), 1 brown (?). When i took it out of the 300zx the orange and brown were connected to the ecu via bullit connectors inbetween a thick white wire. Where do i connect the orange and brown to on the scoob? or what information do they need?
3.Last but not least the 3 ajustments on the front low,med,high, where should they be set?
Any help is much needed,
Many thanks in advance,
Andi
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM