OK so I have the Lambda Link all loomed in but I can't find which wire to connect to on the ECU.
Have tried everyone and none of the colours/info checks out with my ECU!!!

It's for a UK my97 (very early one) has 8S (or S8)on the ECU casing.

If you know or have one fitted on a my97 I'd apritiate some help


Also does the Knock link sensor have to mate to the block or is it suficient to bolt it through a bracket to the block?
Cheers,
Iain.

 

there are 4 blocks plugging into your ecu. lambda signal wire is on block B43 (one of the outer plugs), Pin No.6 (remember pin no 6, not 6th wire, as some pins are empty).

ian

p.s. its a thick (thicker than others) white wire with silver stripes

 

Sorry I've only got 3 plugs, 4 plugs are for the pre my97 (before the facelift)

Pin 5 is a thick white wire, though it's plain (no stripe or ring)
If this is the signal wire which ones the shield?

Iain.

 

This is the diagram I used for my MY97WRX, Hope it helps

[Edited by bruce - 9/27/2002 12:39:40 AM]

 

Bruce,
Thanks mate, will check it out in the morning
and let you know.

Where did the diagram come from?

Iain.

 

oops, sorry dyney.

nice one bruce, have the same type of diagram for my four block ecu, dont know where it came from though

ian