Fitting Magnex Centre Section
20 September 2002, 01:02 PM
#1
Scooby Regular
Thread Starter
Join Date: Feb 2001
Posts: 501
Likes: 0
Received 0 Likes
on
0 Posts
I have a Magnex BB on my MY98 Impreza Turbo and have just ordered a Magnex centre section (with resonator) from Demon Tweeks.
I presume its OK to fit the centre section and keep on the original Subaru downpipe? This shouldn't be a problem, should it?
I will probably change the DP in the future, but my budget doesn't allow for it at the mo
Any help appreciated
Gavin
I presume its OK to fit the centre section and keep on the original Subaru downpipe? This shouldn't be a problem, should it?
I will probably change the DP in the future, but my budget doesn't allow for it at the mo
Any help appreciated
Gavin
20 September 2002, 02:47 PM
#4
Scooby Senior
Join Date: Oct 2000
Location: Zurich, Switzerland
Posts: 3,105
Likes: 0
Received 0 Likes
on
0 Posts
"peice of cake"? Would be if the gottverdammt front bolts were 5mm longer.....especially if you're lying on your back under a wet car trying to fit it with all your 'proper' tools packed away, lol 
Richard
Richard
20 September 2002, 03:31 PM
#6
Scooby Regular
Join Date: Jul 2001
Posts: 21,865
Likes: 0
Received 0 Likes
on
0 Posts
I fitted my Magnex Centre in about 10 minutes time wise.
I did have the advantage of a proper ramp and the car being well above me though!
It is not too bad a job to do, just spray plenty of WD40 on there before starting and let it soak for a couple of hours.
I did have the advantage of a proper ramp and the car being well above me though!
It is not too bad a job to do, just spray plenty of WD40 on there before starting and let it soak for a couple of hours.
Thread
Thread Starter
Forum
Replies
Last Post