Centre Section Install Question
19 September 2002, 01:08 PM
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jul 2002
Location: Suffolk
Posts: 503
Likes: 0
Received 0 Likes
on
0 Posts
Following on from my DIY backbox question yesterday, and reading that the Magnex centre was fairly cheap on another thread, how difficult is it to change the centre section at the same time ?
Are there more hangers involved ? Presumably there'll be more bolts connected to the oem downpipe, and more wd40/elbow grease
required ?
19 September 2002, 01:56 PM
#2
Scooby Regular
There are 2 bolts from the downpipe the the centre section and 2 bolts from the centre to back box.
I think the centre only has 1 hanger the back box has 3.
The down pipe to centre bolts have springs on to alow a little movement in the joint. You may find the original bolts and spring will not fit the new centre. Not a problem, just replace with normal bolts
Iain.
I think the centre only has 1 hanger the back box has 3.
The down pipe to centre bolts have springs on to alow a little movement in the joint. You may find the original bolts and spring will not fit the new centre. Not a problem, just replace with normal bolts
Iain.
Thread
Thread Starter
Forum
Replies
Last Post