mogs132

Hi there,
Ive got a 2005 wrx prodrive edition and the gearbox is dead.
Bought a 2004 gearbox wrx but as I was fitting noticed the driveshafts are different. On my box they go into the box, where as on the new box they are external splines and a roll pin?
Can I just buy shafts that don't go into the box and fit them or is the shaft different length?
Thanks morgan

**jay**

iTrader: (1)

you need too remove the roll pins from your drive shafts and remove the stubs, then the drive shafts slide into the stubs on the box and roll pin back in.

mogs132

But ive got two different diff housings. one box has holes for driveshafts to go into with no roll pin and the new box has stubby shafts attatched to box that the drive shafts fit over

**jay**

iTrader: (1)

Pull the stubs from your shafts or remove the stubs from the box

euan_r

iTrader: (29)

There is no roll pin on ty755 axles the stub is integral as op has found out. Yes, just buy correct axles for different style box, easiest solution.

To remove front stubs on 752,754 you have to strip gearbox down as they are held in place with circlips.

edsel

iTrader: (2)

If you dont need the stub shafts I'll buy them.