Getting the geometry set in Kent
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Nov 2006
Location: At a Shell station near you
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
Getting the geometry set in Kent
Hi chaps anyone of a place i can get the geometry set correctly in Kent, Its just I'm a lazy Bar-Steward and did'nt want to travel to powerstation etc
#2
Try Gatwick Subaru - Dave Hollamby (01293 429824) at Crawley - not too far - they do a full geo check. Get him to put a whiteline arb on at the same time if you haven't already....
#3
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Nov 2006
Location: At a Shell station near you
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
Looking to do a deal on a STI on Sat hopefully fingers x'd, and just want everything set right from day one
Whitline ARB difference is that to OEM thicker/thinner ?
Whitline ARB difference is that to OEM thicker/thinner ?
#4
... a bit thicker (21 or 22mm can't remember) therefore stiffer with better droplinks
It kills the understeer and is a cracking cheap mod - that plus the geo check completely transformed my UK classic
It kills the understeer and is a cracking cheap mod - that plus the geo check completely transformed my UK classic
#5
Scooby Regular
iTrader: (1)
Join Date: Sep 2003
Location: gravesend, kent
Posts: 4,721
Likes: 0
Received 0 Likes
on
0 Posts
don't know where you are in kent mate, but if you're near dartford tunnel there's Elite in rainham that did a fine job on my classic and a company called Mocom Racing (there's a site link in the essex section) that are in North Weald that seem to have had good reports
i'll be heading to one of these myself when i get my **** in gear
i'll be heading to one of these myself when i get my **** in gear
#7
Scooby Senior
iTrader: (1)
Im in Chatham, and always used to go to Elite ever since they sorted bad geometry on a Ford I owned a few years back after the wife kerbed it softly in the snow. No-one local could get it right.
But, I have just had the full T25 setup put on mine, so wont need anything done for a while.
Best to allow a morning as you seem to wait for an hour.
But, I have just had the full T25 setup put on mine, so wont need anything done for a while.
Best to allow a morning as you seem to wait for an hour.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM